How to stone waxing is better?

With the stone in the extensive use of people's lives, people living in the stone has become a beautiful landscape. Stone as a relatively high-end building materials, daily maintenance is extremely important. The right stone conservation in order to better show the stone's quality and beauty. Conservation of stone, stone waxing also major problem. This article introduces you to the specific stone waxing program.

(A), stone floor cleaning Sandstone

Stone ground clean and bright, cloth wax evenly, no stains.

(B), stone floor cleaning, waxing, polishing and maintenance procedures

1, from the wax:

Tools and materials: brush machine with water tanks, washing scouring needle seat with a black brush (brown, red, scouring brush), suction machine, suction skin scraping wax from the water.

(1) to open the machine to the work site, set a good washing needle seat, and even scouring brush;

(2) Install a water tank with good water from the wax;

(3) pressing the power switch on the fuselage, so the chassis driven scouring brush needle seat rotation.

Note: When the handle up, the body moves to the right; the handle down, body to the left;

(4) pressing the lever will play a tank of water evenly rub the wax on the ground;

(5) control of the machine direction, from left to right, back and forth 2 or 3 times;

(6) of the alternating up and down about 10 cm;

(7) has been completed, with a suction machine to suck water from the wax;

(8) corner position with long-handled brush drag wiping hands twice;

(9) twice with water;

(10) to be carried out after the ground dried wax.

2, waxing:

Tools and materials: wax off the tractor, mop bucket, squeeze water heater, the end of wax, face wax.

(1) to drag down the wax off the wax caps in the rack;

(2) the saturated wax tractors;

(3) pressing the water heater on the tractor to the trailer on the folder until the wax does not drip;

(4) the wax evenly coated on the ground;

(5) has been completed, until the wax dry, polish with a polishing machine (1500 r / min).

3, high-speed floor polishing machine of Practice:

(1) hand on the handle down firmly, so that base tilt, and then in the middle of the bottom wheel safety needle seat hundreds of clean brush (white);

(2) the body flat, pull the handle to control the dial up, so dial with scouring brush close to the ground;

(3) When power switch, the dial to 1000 r / min, then polishing the floor;

(4) polishing can not walk too fast, should be maintained at 50 m / min speed.

(5) to be overlap between lines 1 / 3, so as to avoid leakage of polishing.

Note:

A, Slate objects around the use of the machine;

B, you must use three power outlet, there must be ground or leakage protection, inspection machine, unplug after use;